Chapter 1 Getting Started
Configuring your test
30
HST-3000 Ethernet Testing User’s Guide
3 Select a test mode for the application. One of the
following occurs:
– If you are selecting the test mode the first time for an
application, the HST immediately configures the test,
and the Summary Results screen appears.
– If you are selecting a different test mode for an appli-
cation, a “Please Wait ... Reconfiguring Test” message
appears briefly, the message disappears, the HST
configures the test, and then the Summary Results
screen appears.
4 To review or change the current test settings, press the
Configure navigation key.
The Summary Settings menu appears, listing each of the
key settings required to run your test.
– If the settings meet your test requirements, and if you
do not need to change any of the settings on the other
configuration menus, press Home to return to the
Results display, and then press the Restart soft key to
clear statistical and historical results and restart the
test.
– If you need to change the settings, proceed to “Speci-
fying test mode and network visibility settings” on
page 30 and “Specifying basic test settings” on
page 35.
For information about purchasing options for the HST-3000,
contact your JDSU representative or your local JDSU sales
office. You can also contact JDSU through the company web
site, www.jdsu.com.
Specifying test
mode and
network
visibility
settings
Before testing, you should select the test mode for your appli-
cation, specify a unit identifier, and specify additional settings
that impact the instrument and certain test features during
To Next Page
Loading...
