Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
52
HST-3000 Ethernet Testing User’s Guide
3 Use the left and right arrow keys to go to the Ethernet
menu (see Figure 20).
4 Specify values for the following settings:
Figure 20 Ethernet configuration menu
Setting Parameters
Source Type – Factory Default
– User Defined
Indicate whether you want
traffic generated by the HST
to carry the factory default
MAC address, or a user
defined address. If you
specify User Defined, a
Source MAC setting
appears on the menu.
Source MAC If you indicated that the
Source Type was User
Defined, specify the source
MAC address for all traffic
generated by the HST.
Tx Payload – Acterna
– BERT
To Next Page
Loading...
