Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
66
HST-3000 Ethernet Testing User’s Guide
For example, the incoming frames must pass the filter to be
analyzed for a BERT pattern. Local loopback will also only be
performed on frames that pass the filter.
To filter received traffic
1 If you haven’t already done so, launch your application
(see “Launching an application” on page 28), and then
select your test (see the appropriate procedure below):
– “Selecting a layer 2 test” on page 46
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
2 Press the Configure navigation key.
A configuration menu appears.
TIPS:
– If you want to analyze all received traffic, verify that the
Ethernet Filter settings are all Don’t Care.
– If you want to use the JDSU Discovery feature to popu-
late the filter, be certain to Enable the filter.
To Next Page
Loading...
