Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
HST-3000 Ethernet Testing User’s Guide
67
3 Use the left and right arrow keys to go to the Ethernet
Filter configuration menu (see
Figure 24).
4 Specify the values for the following settings:
Figure 24 Ethernet Filter configuration menu
Setting Parameters
Destination Type To analyze frames for a
specific type of destination
address, select one of the
following:
– Unicast
– Multicast
– Broadcast
If you do not want to filter
frames based on the des-
tination address type,
select Don’t Care.
Destination MAC
(if Destination Type is Unicast
or Multicast)
To analyze frames sent to
a specific Unicast or Multi-
cast address, enter the
destination address.
To Next Page
Loading...
