JDS Uniphase HST-3000 - Page 90

Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
68 HST-3000 Ethernet Testing User’s Guide
Source Type – To analyze frames
sent from a specific
address, select
Unicast.
– If you do not want to
filter frames sent from
a specific address,
select Don’t Care.
Source MAC
(if SourceType is Unicast)
To analyze frames sent
from a specific address,
enter the source address.
NOTE: You can option-
ally use the Discover soft
key to discover other
instruments on the circuit,
and then select the source
address for the device you
want to filter traffic for. For
details, see “Using J-Con-
nect to discover another
JDSU test set” on
page 21.
Payload Analysis – To analyze traffic with
a BERT or Acterna
payload, select On.
– If you do not want to
analyze traffic based
on the type of payload
(you want the unit to
monitor live traffic),
select Off.
Setting Parameters