Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
HST-3000 Ethernet Testing User’s Guide
69
Rx BERT Pattern
(if Payload Analysis is On)
To analyze frames with a
specific BERT pattern,
select one of the following:
– 2^23-1
– Inv 2^23-1
– 2^31-1
– Inv 2^31-1
– All Ones
– All Zeros
– User Defined, and
then enter the pattern.
Rx = Tx
(if Tx Payload on Ethernet
configuration menu is BERT)
– To analyze frames
with the same pay-
load specified for
transmitted frames,
select Yes.
– If you want to analyze
frames with a different
payload, select No.
User Payload
(if Rx BERT Pattern is User
Defined)
Enter the pattern carried
in the traffic you are ana-
lyzing.
Setting Parameters
To Next Page
Loading...
