Chapter 3 Ethernet Testing
Using J-Proof to verify layer 2 transparency
74
HST-3000 Ethernet Testing User’s Guide
4 Use the right arrow key to go to the J-Proof Frame config-
uration menu, and then configure the outgoing transpar-
ency frames by specifying the following
:
Encapsulation – To transmit a loop
frame that is not
tagged, select None.
– To transmit a VLAN
tagged loop frame,
select VLAN, and then
specify the VLAN Tag
and User Priority.
– To transmit a Q-in-Q
tagged loop frame,
select Q-in-Q, and
then specify the
CVLAN Tag and User
Priority, and the
SVLAN settings for the
tagged frames.
Setting Parameters
Frame Number Specify the number for the
frame you are currently
configuring. For example,
if you are configuring the
fifth transparency frame
stored on your instrument,
specify “5:.
“Enabled” appears in
parentheses to the right of
the number if the frame is
selected for transmission;
“Disabled” appears if it is
not selected.
You can configure and
transmit up to 20 types of
transparency frames.
Setting Parameters
To Next Page
Loading...
