Chapter 3 Ethernet Testing
Using J-Proof to verify layer 2 transparency
HST-3000 Ethernet Testing User’s Guide
75
Name You can optionally spec-
ify a name for each trans-
parency frame type using
up to 20 characters.
Protocol Select the control proto-
col carried in this type of
transparency frame., or
select User.
If you select User, be cer-
tain to specify the frame
type (DIX, 802.3-LLC, or
802.3-SNAP).
Type The appropriate frame
type for the protocol is set
automatically.
For example, if you set the
protocol to STP; the type
is automatically set to
802.3-LLC, and the DSAP,
SSAP, and CTL values
are set as appropriate.
If you specified a User
protocol, be certain to
specify the frame type too.
Setting Parameters
To Next Page
Loading...
