This function is normally not used in land mode. It was
addressed above in setting up cruise mode.
This function is normally not used in land mode. It was
addressed above in setting up launch and cruise modes.
In
FUNC.LIST highlight DIFFEREN. Press the Selector
to access the Aileron differential menu. Highlight the
land aileron value then press the Selector to access that
value. With the flight mode switch in the lower land mode,
give a full right aileron command and rotate the Selector
to achieve the desired aileron differential for land.
Note: Reverse differential is common for landing
mode to give greater roll control when flaps are
deployed.
Press the Selector to store the value. Now rotate the
Selector to highlight the land flap value and adjust it to
the desired position. Press the LIST button to return to
the Function Mode screen.
A few pilots prefer to have variable camber adjustment
during launch. This enables last minute adjustments
based on wind and winch conditions.
Important: The flaperon and elevator values in the
camber mix menu are based on a percentage of the
programmed flap rate. The flap rates are defaulted
to 0% from the factory, so flaperon and elevator mix
values have no effect until the flap rate values are
set. Because of this, it’s mandatory to first adjust the
flap rates before adjusting the flaperon and elevator
camber mixes. Also remember that changing the flap
rate values affects the flaperon and elevator camber
mix.
Flaperon Mix
In FUNC.LIST highlight Flaprn MX. Press the Selector
to access the Flap Rate menu. Highlight the land down
value then press the Selector to access this value. With
the flight mode switch in the lower position mode, move
the left side lever to the lowest position and adjust the
down value to the desired flap position. Now with the
flight mode switch in the lower land mode, move the left
side lever to the uppermost position and adjust the up
value to the desired flap position. Press the LIST button
to return to the Function Mode screen.
Flaperon Mix
Note: You must set flap rate before camber mix.
In
FUNC.LIST highlight Flaprn MX. Press the Selector
to access the Camber Mix menu. Highlight the land
FPRN down value then press the Selector to access
this value. With the flight mode switch in the lower LAND
mode, move the left side lever to the lowest position and
adjust the down value to the desired flaperon position.
Press the Selector to store the value. Now with the flight
mode switch in the lower land mode, move the left side
lever to the uppermost position and adjust the up value
to the desired flaperon position and store by pressing
the Selector. Repeat the process for the up and down
elevator camber mix. Press the LIST button to return to
the Function Mode screen.
To Next Page
Loading...