Flaperon Mix Delay
The camber adjust menu allows the programming of a
delay from 0 to 2 seconds. This delay affects the flap,
flaperon and elevator presets when switching from one
flight mode to another. When inhibited, no delay occurs
and the servo immediately transitions from one preset trim
position to another when the flight modes are switched.
With a delay programmed, the transition is smooth
relative to the delay time. You can program a break-off
function to override the delay, based on a selected elevator
stick position. For this setup, we will program a .5 second
delay for land.
In FUNC.LIST highlight FM Delay. Press the Selector to
access the Camber Adjust menu. Highlight the land delay
value then press the Selector to access this value. Rotate
the Selector to adjust the value to .5s (seconds) Press
the Selector to store the value. Press the LIST button to
return to the Function Mode screen.
In
FUNC.LIST highlight AILRUD M. Press the
Selector to access the Aileron-to-Rudder mix menu.
Highlight the land left value then press the Selector to
access that value. With the flight mode switch in the lower
land mode, give a full left aileron command and rotate the
Selector to achieve the desired left rudder throw. Press
the Selector to store the value. Now rotate the Selector
to highlight the land right value and adjust it to the
desired position. Press the LIST button to return to the
Function Mode screen.
Setup Sheet (Sailplane)
To Next Page
Loading...