When setting up a new model you should reset all
parameters to their default or factory settings before
proceeding with any other programming. This ensures
there are no program mixes, trims or other functions left
over from a previous model or programming session.
1. In the SYSTEM Menu, highlight and select MDL
Reset using the Selector.
2. Press the CLR button that is next to RES
on the display.
3. Press the lowermost button next to YES on the display
to reset all data for this model.
4. Return to the SYSTEM Menu by pressing
the LIST button.
To set up a new model, first select the desired model
memory. Generally an unused model memory is selected.
However, memory that already contains data for another
model may be used, as long as data for that model is no
longer required since any data in that memory will be
lost.
1. In the SYSTEM Menu, highlight and select Model
SEL using the Selector. The currently selected model
number displays. If you want a different model,
highlight and select the displayed model and a list of
models will appear. Scroll up and down the list using
the Selector.
2. Use the Selector to highlight and select the desired
model memory.
3. Return to the SYSTEM Menu by pressing the LIST button.
1. To access the System menu [SYSTEM M.], hold
down the ENT button while turning the transmitter on.
SELECT A MODEL MEMORY
To Next Page
Loading...