JR X9503 2.4 - Step #2 System Mode; Step #3 Selecting a Model Memory; Step #4 Selecting Model Type; Step #5 Naming a Model

Step #2- System Mode
Step #3 Selecting a Model Memory
Step #4 Selecting Model Type
Step #5 Naming a Model
S-42
S-43
Enter the System Mode by depressing and holding the
ENT button while turning on the transmitter.
Depress the Selector to enter the model select menu.
Highlight
Model SEL and depress the Selector to access
the 50 available model memories. Rotating the Selector
allows memory model selection. Choose the memory
(1–50) you intend to store the current model in, then
depress the Selector to store that memory position.
Press the LIST button to return to the SYSTEM M. list.
In
SYSTEM M. list, highlight Type SEL. Depress the
Selector to access the Model Type Selection menu.
Highlight
GLID then depress the Selector to store the
glider programming. Press the LIST button to return to
the System Mode screen.
In the
SYSTEM M. list, highlight MDL Name. Depress
the Selector to access the model name menu. Rotate the
Selector to position the cursor under the desired position
and press to access the alphanumeric list. Highlight the
desired figure. Depress the Selector to place the selected
figure in position. Rotate the Selector to advance the
cursor, allowing the selection of another figure. Pressing
the LIST button will store the name and return to the
System Mode screen.