The Copy function is part of the Model SEL function
and allows you to copy the current model memory into
another model memory in the same transmitter. It is not
used to transfer the model to another transmitter or to a
Data Safe unit – the DATA TRANSFER function provides
for these activities.
The Copy function can provide some insurance against
losing programs (helicopter setups) that may have
been very time-consuming to create. You should use
the Copy function to make a backup copy of the model
memory after you have completed, tested and refined the
programming.
Making a backup copy protects you from losing the
original program while allowing you to experiment with
the original program. You can restore the original settings
by copying the backup copy back to the original model
memory.
1. Select the model to copy – see Model SEL description
at the beginning of the HELI section.
2. Highlight and select Model SEL in the SYSTEM Menu.
Highlight and select Select to obtain the Copy display.
The display shows the currently selected model on top
with a down arrow pointing to the lower model memory
that the current model will be copied into. The data in
the lower model memory will be entirely replaced by the
data in the currently selected model, so be sure the lower
model is either empty or contains data no longer required.
To set up a new model, first select the desired model.
Generally, an unused model memory is selected.
However, you can use a model containing data for another
model, as long as you no longer need the data, as any
information in that memory will be lost.
1. Bring up the SYSTEM Menu by holding down the
ENT button while turning the transmitter on.
1. In the SYSTEM Menu, highlight and select Model
SEL using the Selector.
2. Use the Selector to highlight and select the desired
model number.
3. Return to the SYSTEM Menu by pressing the
LIST button.
To Next Page
Loading...
Need help?
General
