System mode is the foundational programming. The
screens include model name, model reset, modulation,
data transfer, etc.—functions you typically set once and
seldom change.
To enter System Mode:
Press ENT and hold while turning on the transmitter.
The screen should appear as follows.
System mode contains the following screens:
Model select allows you to store and select up to 50
different models.
Note: When you set up a new model, select an
unused model memory. If you select a current model
memory, reset the model to factory default settings
before programming the new model. See model reset
page S-7.
1. In the
SYSTEM Menu, highlight and select Model SEL
using the Selector.
2. Use the Selector to highlight and select the desired
model number.
3. Press the LIST button to return to the SYSTEM Menu.
To Next Page
Loading...
Need help?
General
