You can assign Flap and Auxiliary functions to operate
from several different switches, buttons or the throttle
stick. In device select, highlight the desired flap or aux
function and press the Selector to access the available
switches you can program to operate each function.
Select the desired switch by highlighting it and press
the Selector.
Activating / Inhibiting Channels
You can inhibit Channels 5 (motor), 7–9, to use them as
slave channels in programmable mix. Highlight the ACT/
INH below the desired channel. Press the Selector to inhibit
or activate the channel.
This screen allows the selection of V-tail, dual flap and,
when dual flaps are activated, aileron-to-flap trim.
To access Wing type in
System mode list, rotate the
Selector to highlight
Wing TYPE. Then press to access
the wing type screen.
If your sailplane has a V-tail, activate the V-tail function by
highlighting
INH and pressing the Selector.
If your sailplane has dual flaps, activate the dual flap
function by highlighting
INH and pressing the Selector.
If you choose to have aileron trim to also affect the flaps,
activate the AILE-FLAP trim function.
To Next Page
Loading...