4.11.2
Negotiating narrow aisles with wire-guided trucks (o)
WARNING!
Unauthorised entry of narrow aisles by other trucks or people can cause
accidents
Unauthorised personnel must not enter narrow aisles (truck lanes in racking systems
with safety distances < 500 mm), nor must any personnel cross through them. These
work areas must be marked and identified accordingly.
u
Carry out a daily inspection of the safety mechanisms on the truck or the racking
system to avoid hazards and to protect personnel.
u
These must not be rendered ineffective, misused, adjusted or removed.
u
Report any defects to your supervisor immediately.
u
Mark defective truck and take out of service.
u
Do not return the industrial truck to service until you have identified and rectified
the fault.
u
Tag out faulty racking systems and block them for entry.
u
Return the truck to service only when you have identified and rectified the fault.
u
Note DIN 15185 Part 2.
u
Narrow aisles must only be entered by trucks which are designated for this
purpose.
u
Before entering a narrow aisle, the operator must look for people or other trucks in
the aisle. Never enter an aisle where there are people or other trucks. If there are
people or trucks in the aisle, stop the truck immediately.
164
04.19 en-GB
To Next Page
Loading...
Need help?
General
