2.2 Lifting the basic truck by crane
Item Component
80 Support to protect the crane slings from sharp edges
WARNING!
Crane slings can tear, resulting in accidents
Crane slings can tear when routed over sharp edges, causing the load to fall.
u
Do not route the crane lifting gear over sharp edges. If this is not possible, protect
the crane lifting gear with suitable supports such as foam.
u
Lifting slings should be fastened to the harness in such a way that they do not
come into contact with any parts of the truck when it is being raised.
Safe lifting of the basic truck by crane without mast
Requirements
– Position the support arm (18) in middle of the swivel traverse frame (25) and
secure it with lashing straps to prevent accidental movement.
– Park the truck securely, see page 191.
– Remove the battery from the truck's battery compartment, see page 82.
– Remove the mast. The mast can only be removed by the manufacturer's specialist
customer service personnel who have been trained to do this. In exceptional
cases this task may be performed by a customer service organisation authorised
by the manufacturer.
Tools and Material Required
– Crane lifting gear, capacity see page 35.
– A ladder if necessary.
54
04.19 en-GB
To Next Page
Loading...
Need help?
General
