4.8 Travel
WARNING!
Incorrect travel can cause accidents and injury
Incorrect travel can cause accidents and therefore injury to the operator and / or third
parties.
u
Always transport a load outside the narrow aisle as low as possible, allowing for
ground clearance.
u
Do not lean out of the truck while travelling.
u
Make sure the travel routes are clear.
u
Adapt your travel speed to the route conditions, the work area and the load.
u
Make sure you have sufficient visibility when reversing.
u
Ensure that there is nobody in the hazardous area when carrying out travel and
hydraulic operations.
u
Instruct other people to move out of the hazardous area of the truck.
u
Stop working with the truck if people do not leave the hazardous area.
WARNING!
Collision hazard when operating the truck
Collisions with personnel and equipment can result if the truck is operated with open
panels and covers.
u
Do not operate the truck unless the panels and covers are closed and properly
locked.
The truck can be operated in 3 modes:
– Free ranging in the apron field (FR)
– Rail guided (RG), see page 159.
– Wire guided (WG), see page 164.
The operating mode used depends on the guide system of the racking systems in
question.
153
04.19 en-GB
To Next Page
Loading...
Need help?
General
