3.4 Checking, putting on and taking off the seat belt
WARNING!
Travelling without a seat belt increases the risk of injury.
Accidents or personal injury can result if the seat belt is not worn or is modified.
u
Always put the seat belt on before starting the industrial truck.
u
Do not modify the seat belt.
u
Damaged or non-operational seat belts must be replaced by trained personnel.
u
Seat belts must always be replaced after an accident.
u
Only original spare parts must be used for retrofits or repairs.
u
Report any defects immediately to your supervisor.
u
Remove the truck from service until a functional seat belt has been fitted.
NOTICE
The driver must check the operation and condition of the seat belt each day before
using the industrial truck.
Z
Protect the seat belt from contamination (e.g. cover it when the truck is idle) and
clean it regularly. Frozen belt locks or pulleys must be thawed out and dried to
prevent them from freezing up again.
The temperature of the warm air should not exceed +60 °C!
127
04.19 en-GB
To Next Page
Loading...
Need help?
General
