Jungheinrich EFX 413 User Manual

4.4 Tilt safety device
Z
Depending on the tilt test the EFX may be supplied with tilt safety devices (36). The
tilt safety devices are fitted to the left and right of the rear truck chassis. When a tilt
safety device (36) is used, under the right side panel (42) an "X" is engraved in the
chassis (41) after the serial number (see page 43).
WARNING!
Missing tilt safety devices can result in
loss of stability
The truck can tip over if it is operated either
without or with incorrectly adjusted tilt
safety devices.
u
Before starting, check the truck to ensure
the tilt safety devices are present.
u
Before starting, check the truck to ensure
the settings are correct.
NOTICE
For a new drive wheel, the distance from
the tilt safety device (36) to the ground
should be 10 mm to 12 mm.
42
41
36
69
04.19 en-GB

Jungheinrich EFX 413 Specifications

General

Brand	Jungheinrich
Model	EFX 413
Category	Trucks
Language	English