6.2 Emergency stop device
When the automatic emergency stop device applies (e.g. if the wire is abandoned,
electrical steering fails) the truck brakes to a halt. Determine the cause of the fault
and eradicate it before starting up the truck again. When starting the truck again,
follow the manufacturer's instructions as indicated in the present operating
instructions (see page 131).
Switching off the truck with the ISM access module after the automatic
emergency stop system has been triggered (
o
)
Requirements
– The truck has been braked to a halt by the automatic emergency stop system.
– Event messages are shown in the driver's display.
Procedure
• Press the red button on the ISM access module.
• Press the red button on the ISM access module again and hold it down for at least
2 seconds.
The truck is switched off.
6.3 Load handler emergency lowering
WARNING!
Risk of accidents / material damage through automatic lowering of load
handler
If the load handler is in the rack, emergency lowering is not to be carried out. Due to
leakage losses in the hydraulic system there is also the risk that the rack could be
damaged by the load handler lowering.
u
Prevent the load handler from lowering further, e. g. with a sufficiently strong chain.
u
Report any defects immediately to your supervisor.
u
Arrange for trained personnel to recover the truck as soon as possible.
u
Mark defective truck and take out of service.
u
Do not return the industrial truck to service until you have identified and rectified
the fault.
211
04.19 en-GB
To Next Page
Loading...
Need help?
General
