Industrial Truck Operation
Requirements
– Prepare the truck for operation, see page 138 or see page 139.
– Carry out a mast reference run (main lift) to adjust the height display, see
page 147.
Procedure
• Press and hold down the dead man's switch (20).
• Fully lower the load handler:
• Turn the "hydraulic functions" control lever (113) anticlockwise.
• Raise the load handler so that it is free of the ground:
• Turn the "hydraulic functions" control lever (113) clockwise.
• Determine the travel direction:
• Pushing the travel direction switch (105) to the right = travel in load
direction (164).
• Pushing the travel direction switch (105) to the left = travel in drive
direction (165).
• Press the accelerator pedal (22).
Z
The travel speed is infinitely controlled by the accelerator pedal (22). The further
the accelerator pedal (22) is pressed, the greater the travel speed.
• Use the steering wheel (5) to steer the truck in the required direction.
The truck travels in the required direction at the requested speed.
154
04.19 en-GB
To Next Page
Loading...
Need help?
General
