WARNING!
Unauthorised lowering speeds can cause accidents
The line break safety valve in the Main Lift hydraulic cylinders stops the load handler
from lowering if the lowering speed is out of range (> 0,6 m/s). If the safety valve
applies for an unauthorised lowering speed, determine the cause.
u
If there no leakage in the hydraulic system, raise the Main Lift slightly and then
lower it again slowly.
u
Report any defects immediately to your supervisor.
u
Mark defective truck and take out of service.
u
Do not return the industrial truck to service until you have identified and rectified
the fault.
u
Spilled, leaking hydraulic oil must be removed immediately with an appropriate
bonding agent.
u
The bonding agent / consumable mixture must be disposed of in accordance with
regulations.
172
04.19 en-GB
To Next Page
Loading...
Need help?
General
