Activating the drive wheel brake
Requirements
– Drive wheel brake wheel.
– Truck parked securely.
Procedure
• Prevent the truck from moving accidentally, e. g. by placing wedges under the
wheels.
• Disassemble the drive compartment cover (35), see page 334.
• Remove the set screws (184) from the drive wheel brake (187).
• Fit the set screws (184) with the two hex. nuts to the bracket (185) above the drive
wheel brake (187).
• Fit the drive compartment cover (35), see page 334.
• When using the truck again, check the braking deceleration.
The drive wheel brake can now be applied without current. The industrial truck can
no longer be pushed.
WARNING!
Only return the truck to service when you have identified and rectified the fault.
228
04.19 en-GB
To Next Page
Loading...
Need help?
General
