Adjusting the steer angle
Requirements
– Load handler fully lowered, see page 171 or see page 211.
Tools and Material Required
– Open-ended spanner (opening: 14)
Procedure
• Switch off the truck; to do this:
• Turn the key in the key switch (8) to the left as far as the stop and remove the
key.
•
Press the red button of the ISM access module (o) twice in a row.
• Press the emergency disconnect switch (9).
• Disconnect the battery.
• Disassemble the drive compartment cover (35), see page 334.
• Using the open-ended spanner, set the wheel (38) in the required direction by
turning the hex. bolt (188) on the steering potentiometer (189).
Z
When setting an angle of more than 4 degrees it is advisable to relieve the drive
wheel (38) by safely raising or jacking up the truck. see page 332.
The steering angle has now been set.
WARNING!
Only return the truck to service when you have identified and rectified the fault.
230
04.19 en-GB
To Next Page
Loading...
Need help?
General
