Procedure
WARNING!
An extended mast can cause accidents
Be aware of the ceiling height when raising the load handler!
Fully raise the load handler.
• Switch off the truck and remove the key if applicable.
• Disconnect the battery.
WARNING!
Risk of accidents when working under an unsecured load handler
Do not place the work platform, lifting platform or safety ladder underneath an
unsecured load handler.
u
Instruct other people to move out of the hazardous area of the industrial truck.
u
Never reach or climb into moving truck parts.
u
Never stand underneath a raised load handler.
Position the work platform, lifting platform or safety ladder directly next to the
industrial truck.
• From your position on the work platform, lifting platform or safety ladder:
• Lubricate lift chains.
• Clean the running faces in the mast sections and apply grease.
Z
Lubrication diagram see page 328.
Lubricant see page 329.
• Remove the work platform, lifting platform or safety ladder.
• Connect the battery to the truck.
• Switch the truck on.
• Fully lower the load handler.
Lift chains lubricated and the contact surfaces in the mast sections cleaned and
greased.
345
04.19 en-GB