• If the hydraulic oil level is below the "MIN" mark on the dipstick (260), add new
hydraulic oil in accordance with the consumables table to reach the upper "MAX"
mark on the dipstick (260).
Z
The hydraulic oil volume between the "MIN" and "MAX" marks on the
dipstick (260) is approx. 2,85 l.
• Trucks with bio-based hydraulic oil have a warning notice on the hydraulic
reservoir: “Add bio-based hydraulic oil only”. In this case you may only use
"Plantohyd 22 S" bio-based hydraulic oil to replenish the hydraulic reservoir.
• Trucks with normal hydraulic oil have a warning notice on the hydraulic
reservoir: “Add hydraulic oil”. In this case you may only use hydraulic oil "HLP
D22 with a 2% share of Additiv 68 ID" to fill the hydraulic reservoir.
WARNING!
You cannot change from BIO hydraulic oil "Plantohyd 22 S" to hydraulic oil "HLP
D22". The same applies to changing from hydraulic oil "HLP D22" to bio hydraulic oil
"Plantohyd 22 S".
Mixed operation with hydraulic oil "HLP D22" and BIO hydraulic oil "Plantohyd 22 S"
is not permitted.
• Check the hydraulic oil level again and top up if necessary.
When you have reached the upper "MAX" marking on the dipstick (260), the
hydraulic reservoir (261) is completely full.
• Screw the breather (259) and dipstick (260) clockwise into the hydraulic
reservoir (261).
• Fit the drive compartment cover, see page 334.
349
04.19 en-GB
To Next Page
Loading...
Need help?
General
