1.2.2 Inspection contents
The following points must be checked:
1.2.2.1 Standard equipment
Brakes
The secure seating of the connections and cables and for damage
Brake linings for wear and damage
Electrical system
Cables and engine are secure and for damage
Warning and safety devices are in accordance with the operating instructions
Function of display and controls
The function of the emergency disconnect and for damage
Contactors and/or relays for wear and damage
Note: If the service seal is damaged, check the internal main current fuses for damage
and check their ratings. Attach a new seal to the combined control unit after the test.
The electric wiring for damage (insulation damage, connections) and the fuse ratings
Electrostatic discharge strap or chain is present and for damage
Power supply
The function of the battery latch and battery attachment and for damage
The function and secure seating of the battery connector and for damage
Travel
The function of the deadman switch and for damage
The function and secure seating of the sensors and for damage
Drivetrain bearings for wear and damage
The drive support plate is secure and for damage
Transmission for noise and leaks
Wheel bearings and attachment for wear and damage
Wheels for wear, damage and secure mounting
Chassis/structure
Industrial truck for damage and leaks
The secure seating of the chassis and screw connections and for damage
The battery rollers and any support rubber to ensure presence and function
Labels are legible, complete and plausible
The secure seating of the driver's seat and the function of the adjustment mechanism
Doors and/or covers for damage
The function of the battery panel gas strut and for damage
The mast bearings for wear
The secure seating of the mast
367
04.19 en-GB