– Two identical wedges.
– Wooden plank, pallet or rubber mat.
Procedure
• Secure the support frame (18) with lashing straps to prevent accidental
movement.
• From the fork carriage (19) to the front of the transport vehicle, form a positive fit
using wooden beams, a pallet or a rubber mat (95).
• Relieve the drive wheel (38). To do this, place the hard wooden blocks (94) under
the chassis on either side at the height of the drive wheel (38).
• Place wedges (93) in front of the load wheels (30) to prevent the truck from
moving accidentally.
NOTICE
When assembling the fastening belts be aware of the electric and hydraulic line
routing. Prevent the electric and hydraulic lines from being damaged by the fastening
belts.
• Secure the truck with two lashing straps (92) to the left-hand and right-hand
attachment points (79) between the swivel traverse frame (25) and the truck
chassis:
• Thread the lashing straps (92) through the attachment points (79)between the
swivel traverse frame (25) and the truck chassis.
• Secure the lashing straps (92) to the lashing rings (85).
• Tighten the lashing straps (92) with their tensioners.
• Secure the truck with two lashing straps (91) to the left-hand and right-hand
attachment points (78) on the overhead guard (11):
• Thread the lashing straps (91) through the attachment points (78) on the
overhead guard (11).
• Secure the lashing straps (91) to the lashing rings (88).
• Tighten the lashing straps (91) with their tensioners.
The basic truck with lift mast is secure for transport.
65
04.19 en-GB
To Next Page
Loading...
Need help?
General
