WARNING!
The gases produced during charging can cause explosions
The battery produces a mixture of nitrogen and hydrogen (electrolytic gas) during
charging. Gassing is a chemical process. This gas mixture is highly explosive and
must not be ignited.
u
Switch the charging station and truck off first before connecting/disconnecting the
charging cable of the battery charging station to/from the battery connector.
CAUTION!
Short circuits can result in fire
Damaged cables can cause short circuits, setting the truck and battery on fire.
u
Before closing the battery cover make sure that the battery cables are not
damaged.
u
Report any defects immediately to your supervisor.
u
Mark defective truck and take out of service.
u
Do not return the industrial truck to service until you have identified and rectified
the fault
Preparing the battery for operation after charging
Requirements
– The battery (99) is fully charged.
Procedure
• Switch off the charger.
• Disconnect the charging cable from the battery connector (33).
• Check all cables and connectors for visible signs of damage.
• Connect the battery connector (33) to the truck.
• Close the battery cover (29), see page 76.
After the battery charge the truck is ready for operation.
80
04.19 en-GB
To Next Page
Loading...
Need help?
General
