Juniper ACX5048 - Page 135

3. Locate the power cord or cords shipped with the router; the cords have plugs
appropriate for your geographical location. See “AC Power Cord Specifications for an
ACX5000 Router” on page 54.
WARNING: Ensure that the power cord does not block access to device
components or drape where people can trip on it.
4. Connect each power supply to the power sources. Insert the coupler end of the power
cord into the AC power cord inlet on the AC power supply faceplate.
5. Push the power cord retainer onto the power cord (see Figure 37 on page 115 and
Figure 38 on page 115).
Figure 37: Connecting an AC Power Cord to an AC Power Supply in a 1 U
ACX5048
1— Power cord retainer
Figure 38: Connecting an AC Power Cord to an AC Power Supply in a 2 U
ACX5096
6. If the AC power source outlet has a power router, set it to the OFF (O) position.
NOTE: The router powers on as soon as power is provided to the power
supply. There is no power router on the device.
7. Insert the power cord plug into an AC power source outlet.
115Copyright © 2015, Juniper Networks, Inc.
Chapter 11: Connecting the Router to Power