Juniper ACX5048 - Page 50

Figure 14: AC Power Supply LEDs on an ACX5000 Router
g050008
AC OK
DC OK
Fault
g000802
AC OK
DC OK
Fault
Table 14 on page 30 describes the LEDs on the AC power supplies.
Table 14: AC Power Supply LEDs on an ACX5000 Router
DescriptionStateColorLED
The power supply is disconnected from power, or power is not coming
into the power supply.
OffUnlitAC OK
Power is coming into the power supply.On steadilyGreen
The power supply is disconnected from power, or the power supply is
not sending out power correctly.
OffUnlitDC OK
The power supply is sending out power correctly.On steadilyGreen
An error has been detected in the power supply. Replace the power
supply as soon as possible. To maintain proper airflow through the
chassis, leave the power supply installed in the chassis until you are
ready to replace it.
On steadilyAmberFault
NOTE: If the AC OK LED and the DC OK LED are unlit, either the AC power
cord is not installed properly or the power supply fuse has failed. If the AC
OK LED is lit and the DC OK LED is unlit, the AC power supply is installed
properly, but the power supply has an internal failure.
Copyright © 2015, Juniper Networks, Inc.30
ACX5048 and ACX5096 Universal Access Router