c. Mark a point P at a distance of 4.3 in. (10.9 cm) on a level line to the right from hole
B.
d. Drill a hole C at a distance of 3.78 in. (9.6 cm) on a level line from point P and install
a mounting screw.
4. For mounting the switch under a desk or other level surface, hold the switch such that
the holes on the bottom panel of the switch align with the screw heads, lift the switch,
and then slide the switch forward or backward until it locks in place. See
Figure 34 on page 134.
Figure 34: Mounting the EX2300-C Switch Under a Desk or Other Level
Surface by Using Screws
5. (Optional) Attach the standard cable lock to the security slot on the switch:
a. Fasten the cable to a desk or a rack and set the lock to unlocked position using the
key.
b. Insert the lock into the security slot on the switch and set the lock to the locked
position using the key. See Figure 35 on page 134.
Figure 35: Securing the EX2300-C Switch by Using the Security Slot
Copyright © 2017, Juniper Networks, Inc.134
EX2300-C and EX2300 Switches Hardware Guide