Mounting an EX2300 Switch in a Recessed Position in a Rack or Cabinet
You can mount an EX2300 switch except the EX2300-C switch model on two posts or
four posts of a rack or cabinet such that the switch is recessed inside the rack from the
rack front by 2 inches. You can use the 2-in.-recess front-mounting brackets provided in
the separately orderable four-post rack-mount kit to mount the switch in a recessed
position.
Reasons that you might want to mount the switch in a recessed position include:
•
You are mounting the switch in a cabinet and the cabinet doors do not closecompletely
unless the switch is recessed.
•
The switch you are mounting has transceivers installed in the uplink ports—the
transceivers in the uplink ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
“Mounting an EX2300 Switch on Four Posts of a Rack or Cabinet” on page 137. To mount
the switch in a recessed position on two posts, follow the instructions in “Mounting an
EX2300 Switch on Two Posts of a Rack or Cabinet” on page 135.
Related
Documentation
• Connecting Earth Ground to an EX Series Switch on page 155
• Rack-Mounting and Cabinet-Mounting Warnings on page 234
153Copyright © 2017, Juniper Networks, Inc.
Chapter 12: Installing the Switch
To Next Page
Loading...
