Juniper EX2300-C - Connecting the Switch to the Network; Connecting a Device to a Network for Out-Of-Band Management; Connecting a Device to a Management Console by Using an; Figure 61: RJ-45 Connector on an Ethernet Cable

CHAPTER 14
Connecting the Switch to the Network
•
Connecting a Device to a Network for Out-of-Band Management on page 167
•
Connecting a Deviceto a Management Consoleby Using an RJ-45 Connector on page 168
•
Connecting an EX2300 Switch to a Management Console by Using Mini-USB Type-B
Console Port on page 169
•
Connecting a Fiber-Optic Cable on page 170
Connecting a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel.
Each device has a management port to which you can connect an Ethernet cable with
an RJ-45connector. Usethe management port toconnectthe device to the management
device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
Figure 61 on page 167 shows the RJ-45 connector of the Ethernet cable supplied with the
device.
Figure 61: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see
Figure 62 on page 168):
1. Connect one end of the Ethernet cable to the management port (labeled MGMT or
ETHERNET) on the device.
2. Connect the other end of the Ethernet cable to the management device.
167Copyright © 2017, Juniper Networks, Inc.