Figure 47: Measurements for Installing Mounting Screws to Mount an
EX2300 Switch on a Wall
4. Place the switch against the wall such that the front panel of the switch faces to the
right side and the holes in the mounting brackets heads align with the mounting screw
heads.
5. Slide the switch chassis to the left or right a bit so that the mounting screws are pushed
into the channels of the holes in the mounting brackets until the switch rests firmly
in place as shown in Figure 48 on page 149.
6. Tighten the mounting screws.
Copyright © 2017, Juniper Networks, Inc.148
EX2300-C and EX2300 Switches Hardware Guide
To Next Page
Loading...
