Juniper EX2300-C - Chassis Status Leds in EX2300 Switches; Figure 12: Chassis Status Leds in EX2300-C Switches; Figure 13: Chassis Status Leds in EX2300 Switches Except the EX2300-C; Table 6: Chassis Status Leds in an EX2300 Switch

Chassis Status LEDs in EX2300 Switches
The front panel of an EX2300 switch has three chassis status LEDs labeled SYS, ALM,
and MST. See Figure 12 on page 16 and Figure 13 on page 16.
Figure 12: Chassis Status LEDs in EX2300-C Switches
1— Chassis Status LEDs
Figure 13: Chassis Status LEDs in EX2300 Switches Except the EX2300-C
Switches
1— Chassis Status LEDs
Table 6 on page 16 describes the chassis status LEDs in an EX2300 switch, their colors
and states, and the status they indicate.
Table 6: Chassis Status LEDs in an EX2300 Switch
State and DescriptionColorLED Label
•
On steadily—Junos OS for EX Series
switches has been loaded on the switch.
•
Blinking—The switch is booting.
•
Off—The switch is powered off or is halted.
GreenSYS
Copyright © 2017, Juniper Networks, Inc.16
EX2300-C and EX2300 Switches Hardware Guide