Juniper EX2300-C - Connecting and Configuring an EX Series Switch (CLI Procedure)

interface ge-0/0/19;
interface ge-0/0/20;
interface ge-0/0/21;
interface ge-0/0/22;
interface ge-0/0/23;
interface ge-0/1/0;
interface xe-0/1/0;
interface ge-0/1/1;
interface xe-0/1/1;
interface ge-0/1/2;
interface xe-0/1/2;
interface ge-0/1/3;
interface xe-0/1/3;
}
}
poe {
interface all;
}
Related
Documentation
Configuration Files Terms•
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 182
• Understanding Configuration Files for EX Series Switches
• EX2300 Switches Hardware Overview on page 3
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the ezsetup script, the switch must have the factory-default
configuration as the active configuration. If you have configured anything on
the switch and wantto run ezsetup, revert tothe factory-default configuration.
See “Reverting to the Default Factory Configuration for the EX Series Switch”
on page 186.
Using the CLI, set the following parameter values in the console server or PC:
•
Baud rate—9600
•
Flow control—None
179Copyright © 2017, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration