Juniper EX2300-C - Figure 40: Mounting the Switch to the Front Posts of a Rack; Figure 41: Sliding the Rear Mounting-Blades into the Side Mounting-Rail

Figure 40: Mounting the Switch to the Front Posts of a Rack
2—1— Front-mounting bracketSide mounting-rail
8. Have a second person secure the front of the switch to the rack by using the appropriate
screws for your rack.
9. Slide the rear mounting-blades into the side mounting-rails. See Figure 41 on page 140.
Figure 41: Sliding the Rear Mounting-Blades into the Side Mounting-Rail
3—1— SwitchRear mounting-blades
2—Side mounting-rail
10. Attach the rear mounting-blades to the rear post by using the appropriate screws for
your rack. Tighten the screws.
11. Ensure that the switch chassis is level by verifying that all the screws on the front of
the rack are aligned with the screws at the back of the rack.
Related
Documentation
Mounting an EX2300 Switch on Two Posts of a Rack or Cabinet on page 135•
• Connecting Earth Ground to an EX Series Switch on page 155
Copyright © 2017, Juniper Networks, Inc.140
EX2300-C and EX2300 Switches Hardware Guide