Juniper EX2300-C - Pluggable Transceivers Supported on EX Series Switches

Table 40: Optical Interface Support for SFP+ Transceivers in EX2300 Switches (continued)
ValueSpecificationEthernet Standard
EX-SFP-10GE-ZRModel number10GBASE-ZR
NOTE: EX2300-C
switches do not
support this
transceiver.
10 GbpsRate
LCConnector type
DualFiber count
1550 nmTransmitter wavelength
0 dBmMinimum launch power
5 dBmMaximum launch power
–20 dBmMinimum receiver sensitivity
–8 dBmMaximum input power
SMFFiber type
9/125 µmCore/Cladding size
–Modal bandwidth
80 km (49.7 miles)Distance
AvailableDOM support
Junos OS for EX Series switches, Release 15.1X53-D50 or laterSoftware required
YesSupport for Virtual Chassis
configuration
Related
Documentation
EX2300 Switches Hardware Overview on page 3•
• Installing a Transceiver on page 193
• Removing a Transceiver on page 195
Pluggable Transceivers Supported on EX Series Switches
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
97Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Transceiver and Cable Specifications