Juniper EX2300-C - Figure 42: Attaching a Cable Guard to an EX2300-C Switch

To mount the switch on a wall:
1. Remove the switch from the shipping carton (see “Unpacking an EX2300 Switch” on
page 123).
2. (Optional) Attach the optional cable guard to protect cable connections:
a. Use the 3 truss-head screws to attach the cable guard to the bottom of the chassis.
b. Use the thumbscrews to fasten or loosen the cable guard so that you can insert
cables. See Figure 42 on page 142.
Figure 42: Attaching a Cable Guard to an EX2300-C Switch
2—1— Thumb screwsCable guard
3. Install three mounting screws on the wall as shown in Figure 43 on page 143.
NOTE: Figure 43 on page 143 shows the bottom panel of an EX2300-C
switch when the switch is viewed from the top. The internal components
and top cover are not shown.
Copyright © 2017, Juniper Networks, Inc.142
EX2300-C and EX2300 Switches Hardware Guide