Juniper EX2300-C - EX2300 Switch Models; Figure 10: Rear Panel of an AC-Powered EX2300 Switch with 48 Gigabit Ethernet Ports with Poe Capability; Figure 11: Rear Panel of an AC-Powered EX2300 Switch with 48 Gigabit Ethernet Ports Without Poe Capability

Figure 10: Rear Panel of an AC-Powered EX2300 Switch with 48 Gigabit
Ethernet Ports with PoE Capability
6—1— Air exhaust openingsUSB port
7—2— Serial number ID labelManagement Ethernet port
8—3— CLEI code labelRJ-45 console port
9—4— AC power cord inletProtective earthing terminal
5—ESD point
Figure 11: Rear Panel of an AC-Powered EX2300 Switch with 48 Gigabit
Ethernet Ports without PoE Capability
6—1— Air exhaust openingUSB port
7—2— Serial number ID labelManagement Ethernet port
8—3— CLEI code labelRJ-45 console port
9—4— AC power cord inletProtective earthing terminal
5—ESD point
Related
Documentation
EX2300 Switch Models on page 11•
• Site Preparation Checklist for EX2300 Switches on page 51
EX2300 Switch Models
The EX2300 switch is available with 12 or 24, or 48 built-in RJ-45 network ports with full
Power over Ethernet (PoE) or Power over Ethernet plus (PoE+) capability on all built-in
RJ-45 network ports (access ports), or no PoE capability. Table 3 on page 12 lists the
EX2300 switch models.
EX2300-C switches have two uplink ports and EX2300 switches except EX2300-C
switches have four uplink ports. Uplink ports do not support PoE.
11Copyright © 2017, Juniper Networks, Inc.
Chapter 1: System Overview