•
Verify that the site meets the requirements described in “Site Preparation Checklist
for EX2300 Switches” on page 51.
•
Read “General Safety Guidelines and Warnings” on page 223, with particular attention
to “Chassis Lifting Guidelines” on page 232.
Ensure that you have the following parts and tools available:
•
2 wall-mounting brackets (provided in the wall-mount kit)
•
12 wall-mounting bracket screws (provided in the wall-mount kit)
•
6 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not provided)
•
Hollow wall anchors rated to support up to 75 lb (34 kg) if you are not screwing the
screws directly into wall studs (not provided)
•
Phillips (+) screwdriver, number 2
To mount the switch on a wall:
1. Remove the switch from the shipping carton (see “Unpacking an EX2300 Switch” on
page 123).
2. Attach the wall-mounting brackets to the sides of the chassis by using four
wall-mounting bracket screws, as shown in Figure 46 on page 146.
145Copyright © 2017, Juniper Networks, Inc.
Chapter 12: Installing the Switch
To Next Page
Loading...
