TIP: When you are powering off the device, the system displays the following
message: Turning the system power off. You can now safely remove the power
cable to completely disconnect the power from the device.
NOTE: You can use the request system reboot commandtoschedule a reboot
of the services gateway.
For more information about halting, powering off, or rebooting the services gateway using
CLI, see the Junos OS Administration Guide.
Resetting the SRX210 Services Gateway
The Reset Config button located at the front panel of the SRX210 Services Gateway
removes the current configuration and resets the device to the default configuration. The
button is recessed in the front panel to prevent it from being pressed accidentally.
NOTE: Pressing and holding the Reset Config button for 15 seconds or more
deletes all configurations on the device and loads and commits the factory
configuration.
Related
Documentation
• Connecting the SRX210 Services Gateway to the Power Supply on page 79
• Grounding the SRX210 Services Gateway on page 82
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
• Using the Reset Config Button on the SRX210 Services Gateway on page 121
• SRX210 Services Gateway LEDs on page 18
85Copyright © 2010, Juniper Networks, Inc.
Chapter 13: Connecting, Grounding, and Powering On the SRX210 Services Gateway
To Next Page
Loading...
