admin@host# exit
admin@host>
Related
Documentation
Connecting an SRX210 Services Gateway to the CLI Locally on page 91•
• Connecting an SRX210 Services Gateway to the CLI Remotely on page 93
• SRX210 Services Gateway Software Configuration Overview on page 97
• Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
• SRX210 Services Gateway Secure Web Access Overview on page 106
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface
This topic includes the following sections:
•
Establishing Basic Connectivity on page 103
•
Configuring Basic System Properties on page 104
Establishing Basic Connectivity
To establish basic connectivity:
1. Connect an Ethernet cable from any of the ge-0/0/1 or fe-0/0/2 to fe-0/0/7 ports to
the Ethernet port on the management device (workstation or laptop).
2. Connect the power cable to the device and a power source. (We recommend using
a surge protector.) Note the following indications:
•
Power LED (steadily green): The device is receiving power.
•
Status LED (steadily green): The device is operating normally.
NOTE: The services gateway functions as a DHCP server and will assign
an IP address to the management device.
3. Ensure that the management device acquires an IP address on the 192.168.1.0/24
subnetwork (other than 192.168.1.1) from the device.
NOTE: If an IP address is not assigned to the management device,
manually configure an IP address in the 192.168.1.0/24 subnetwork. Do
not assign the 192.168.1.1 IP address to the management device, as this IP
address is assigned to the services gateway.
103Copyright © 2010, Juniper Networks, Inc.
Chapter 16: Performing Initial Software Configuration on the SRX210 Services Gateway
To Next Page
Loading...
