Juniper SRX210 - HARDWARE GUIDE REV 3 - Chapter 16 Performinginitialsoftwareconfigurationonthesrx210 Services; Chapter 17 Gateway; SRX210 Services Gateway Software Configuration Overview; Preparing the SRX210 Services Gateway for Configuration

CHAPTER 16
Performing Initial Software Configuration
on the SRX210 Services Gateway
This chapter includes the following topics:
•
SRX210 Services Gateway Software Configuration Overview on page 97
•
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI on page 100
•
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
•
SRX210 Services Gateway Secure Web Access Overview on page 106
SRX210 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX210 Services Gateway for Configuration on page 97
•
Understanding Built-In Ethernet Ports on page 98
•
Mapping the Chassis Cluster Ports on page 98
•
Understanding Management Access on page 99
Preparing the SRX210 Services Gateway for Configuration
When the SRX210 services gateway powers on, it tries to boot the Junos OS from the
default storage media. If the device fails to boot from the default storage media, it tries
to boot from the alternate storage media.
Table 37 on page 97 provides information on the storage media available on the SRX210
services gateway.
Table 37: Storage Media on SRX210 Services Gateway
TypeStorage Media
Default; always presentInternal NAND flash
AlternateUSB storage device
97Copyright © 2010, Juniper Networks, Inc.