Table 44 on page 120 describes different Power LED status settings and their corrective
actions.
Table 44: Services Gateway Power LED Status
Possible Cause and Corrective
ActionMeaningLED Status
Normal indication. No action is required.The device is receiving
power, and the internal
power supply is functional.
Green
Normal indication. No action is required.The Power button has
been pressed and quickly
released. The device is
shutting down or starting
up.
Amber
•
Verify that the AC power cord from
the power source to the device is not
damaged. If the insulation is cracked
or broken, immediately replace the
cord or cable.
•
Ensure that the socket you plug in is
in working condition.
•
Ensure the device has an AC input
voltage between 110 and 240 VAC.
•
If you cannot determine the cause
of the problem or need additional
assistance, contact the Juniper
Networks Technical Assistance
Center (JTAC). See “Juniper
Networks Technical Assistance
Center” on page 122.
The device is not receiving
power.
Off
Related
Documentation
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 113•
• Monitoring the SRX210 Services Gateway Components Using LEDs on page 115
• Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 118
• Using the Reset Config Button on the SRX210 Services Gateway on page 121
• Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 121
• Juniper Networks Technical Assistance Center on page 122
Resetting the Configuration File When the SRX210 Services Gateway Is Inaccessible
You can use the SRX210 Services Gateway's Reset Config button to restore the device's
configuration file when the current one is faulty or fails. You can also change the default
behavior of the Reset Config button.
Copyright © 2010, Juniper Networks, Inc.120
SRX210 Services Gateway Hardware Guide
To Next Page
Loading...
