Table 35: Port Settings for Configuring the Modem on the Services
Gateway End
ValuePort Settings
9600Bits per second
8Data bits
NoneParity
1Stop bits
NoneFlow control
5. In the HyperTerminal window, enter AT.
For more information on the AT commands, see the Junos OS Administration Guide.
An OK response verifies that the modem can communicate successfully with the COM
port on the PC or laptop.
6. Configure the modem to answer a call on the first ring by entering ATS0=1.
7. Configure the modem to accept modem control DTR signals by entering AT&D1.
8. Disable flow control by entering AT&K0.
9. Save modem settings by entering AT&W.
Related
Documentation
Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 94•
• Connecting to the CLI at the User End for the SRX210 Services Gateway on page 95
• SRX210 Services Gateway Software Configuration Overview on page 97
Connecting the Modem to the Console Port on the SRX210 Services Gateway
To connect the dial-up modem to the console port on the services gateway:
1. Turn off power to the services gateway.
2. Turn off power to the modem.
3. Plug one end of the Ethernet cable supplied with your services gateway into the
console port on the services gateway.
4. Plug the other end of the CAT-5e cable (Ethernet cable) into the RJ-45 to DB-9 serial
port adapter supplied with your services gateway.
5. Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter or other adapter appropriate for your modem.
6. Plug the modem adapter into the DB-25 connector on the modem.
7. Connect the modem to your telephone network.
Copyright © 2010, Juniper Networks, Inc.94
SRX210 Services Gateway Hardware Guide
To Next Page
Loading...
