NOTE: Information sent in cleartext is not encrypted and therefore can be
intercepted.
If the device is operating in a Common Criteria environment, see the Secure Configuration
Guide for Common Criteria and Junos-FIPS.
Related
Documentation
Connecting an SRX210 Services Gateway to the J-Web Interface on page 89•
• Connecting an SRX210 Services Gateway to the CLI Locally on page 91
• Connecting an SRX210 Services Gateway to the CLI Remotely on page 93
• Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI on page 100
• Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
• SRX210 Services Gateway Secure Web Access Overview on page 106
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI
This procedure connects the device to the network but does not enable it to forward
traffic. For complete information about enabling the device to forward traffic, including
examples, see the appropriate Junos OS configuration guides.
To configure the software:
1. Verify that the device is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
configure
[edit]
root@#
5. Set the root authentication password by entering a cleartext password, an encrypted
password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
Copyright © 2010, Juniper Networks, Inc.100
SRX210 Services Gateway Hardware Guide
To Next Page
Loading...
