Juniper SRX210 - HARDWARE GUIDE REV 3 - Connecting the Modem to the Console Port on the SRX210 Services Gateway

6. Dial the modem that is connected to the console port on the services gateway by
entering ATDT remote-modem-number. For example, if the number of the modem
connected to the console port on the services gateway is 0013033033030, enter ATDT
0013033033030.
The services gateway login prompt appears.
7. Log in as the user root. No password is required at initial connection, but you must
assign a root password before committing any configuration settings.
Related
Documentation
• Connecting the Modem at the SRX210 Services Gateway End on page 93
• Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 94
• SRX210 Services Gateway Software Configuration Overview on page 97
Copyright © 2010, Juniper Networks, Inc.96
SRX210 Services Gateway Hardware Guide